Feb
17
2017

Overwhelmed by the Complexity of Remodels? This May Help

Basement Waterproofing; Read the DIY Tips for Your Home Improvement If your home’s basement foundation was not appropriately constructed, probably a demoralizing water seeping or condensation situation may occur whenever it rains heavily. Every homeowner will not want this situation to occur, but you don’t need to worry too much because there is a way out. Waterproofing can be an ultimate answer to a leaking basement foundation. First of all; you need to identify an effective waterproofing coating. Given the difficulties of preventing water seeping, the waterproofing will work well if the walls are well constructed. If the walls are not in the perfect condition, start by brushing the loose mortar as well as the broken blocks. Clear dirt, dust, grease, and any other contaminant using a wire brush. Seal the cracks and openings using a fast-dry concrete. However, it is highly recommended to check the manufacturer’s guidelines before you start patching the cracks. Sometimes, the waterproofing is mixed with cement before applying on the cracks. Many homeowners make the mistake of adding too much or too little waterproof, which may cause other problems down the line. However, an excess of waterproof use may imply a stronger sealing to the cracks.
What Research About Services Can Teach You
If you apply a thin waterproof, it might not prevent the seeping appropriately. If the water is seeping at a higher rate, you can add an extra coating to strengthen the first coating. Remember, the waterproof application should be done right at the building material pores. Ensure every crack is properly sealed.
The Best Advice on Services I’ve found
When you start shopping for moisture coating products, you need to be a bit careful to buy the right product. If you come across ‘water repellant’ and ‘waterproof coating’, beware that these are two terms used by many manufacturers interchangeably. Note that, these two terms are totally different. Water repellant is used to coat above the concrete and do not actually prevent water seepage under hydrostatic pressure. On the other hand, waterproofing coatings are usually used to prevent water passage under hydrostatic pressure. It is particularly applied on and below the concrete on both interior and exterior wall surfaces. High water table, faulty gutters, wind-driven rain, and rain runoff flowing towards a building are some of the causes of hydrostatic pressure on many house foundations. It is important for every homeowner to know the difference between a moisture seepage and condensation. To know the cause of wetness on the foundation, place an aluminum foil on the wall and leave it for several days. If you find that the foil’s side in contact with the wall is wet, the possible problem is seepage. If the wetness is on the upper side, there is a condensation problem. However, if both sides of the foil are wet, condensation and seepage are occurring at the same time. Therefore, a dehumidifier can be used to solve condensation problem while a good quality waterproofing coating can stop the seepage issues.

Comments are closed.